Fabrications – Encased (part one of case construction)

We’ll come back to the felted floral round created in the previous tutorial during part three. For the next step, you will need a base fabric, a sheer print fabric, some Angelina, and a stiff stabilizer such as Timtex, and fusible interfacing. These supplies will be transformed into the body of the MP3 case/carrier.

First, cut two pieces of base fabric twice the length of your desired case size. For example, my case is 6 1/2″ wide and 6 1/2″ tall. So I cut my fabrics 6 1/2″ x 13″. (The finished fabric will be folded in half to form the case.)

Cut Base Fabric

Next, press fusible interfacing to the back side of each base fabric piece.

Interfaced Base Fabric

From your sheer print fabric (I used a print organza), cut one piece using the same measurements as you did for your base fabric. This is probably the most important element of this project since the sheer print totally changes the appearance and texture of the base fabric. Although I used yardage, sheer print scarves would probably work quite well in this project.

Sheer Print Organza Layer

To stabilize the case, cut a piece of Timtex or similar heavy stabilizer the same size as your base fabric. If you would prefer a softer case, a cotton batting would make a good substitute. Set it aside for now.

Heavy Stabilizer

Take one piece of your base fabric and spray it with 606 fusible spray, following the directions on the can. I chose 606 because it leaves no evidence of its presence when working with sheer fabrics.

606 Fusible Spray

After your spray dries for a few minutes, pull a small amount of Angelina and sprinkle the fibers on top of the sprayed fabric. (I used Ultraviolet and Peacock.)

Angelina Fibers

Place the sheer print on top of the fibers and move the piece to your pressing area. Top the layers with parchment paper and press for about three seconds on a silk setting. The layers should adhere to each other and now form a single piece of fabric.

Pressing Layer Together

Next, spray the surface of your heavy stabilizer with 505. Position the second (unmodified) piece of base fabric evenly on the stabilizer, and press it in place with your fingers. Turn the stabilizer over, spray the second side with 505, and position your transformed fabric in the same manner.

505 Spray

Your project is now ready for stitching, which we will take up next time.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Rene
Time Treasured

SaveSave

Advertisements

1 Comment

  1. kmom said,

    July 17, 2007 at 4:58 pm

    Amazing. Good photos. Good explanations. And I’m continuing to be in awe of your final results. Thank you!


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: